SUNGANI WOTITSOGOLERA
CSEN1

CSEN1 Combo Sensor Controller

Part Numbers: CSEN1-H-W-ZHA (white enclosure) and CSEN1-H-G-ZHA (gray enclosure)

DESCRIPTION

The CSEN1 is a low voltage Networked Lighting Controller with an integrated passive infrared sensor and a photocell. It is powered via the AUX power from the LED driver. The CSEN1 autodetects both 0-10V Drivers and D4i Drivers to simplify the installation. The product is DLC certified for both indoor and outdoor applications.

MFUNDO

• Mawayilesi pafupipafupi: 2.4 GHz (IEEE 802.15.4)
• Mphamvu ya Kutulutsa kwa RF: +20dBM
• Kutentha kwa Ntchito: -40 ° mpaka +70 ° C
• Chinyezi chogwira ntchito: 10 mpaka 95%, chosasunthika
• Malo Otetezedwa a IP66
• Makulidwe: 3.1” D x 1.6” H (80mm D x 42mm H)
• Input Power: 12-24VDC, 35mA max, 840mW
• Cholinga chowongolera: Kugwira ntchito
• Environmental: Indoor/Outdoor
• Digiri ya kuipitsa: 3
• Adavotera Impulse Voltagndi: 330v

PANGANI ZOGANIZIRA

Below are some recommendations for successful analog dimming using the CSEN1. The analog dimming control wires are referenced as DALI+/DIM+ and Common Ground/DALI-. The dimming signals have a Maximum voltage ya 10V DC.

• Do not ground the Common Ground/DALI- wire to chassis ground; this is a return signal and is critical for proper dimming.
• Mawaya oyimitsa njira atalikirana ndi mizere ya AC ngati nkotheka.
• Kuchuluka kwa 4 DALI-2 / D4i Madalaivala a LED pa wolamulira aliyense, funsani Synapse Support ngati chiŵerengero chachikulu chikufunika.
• Maximum of 8 DIM to OFF LED Drivers for DIM to OFF Designs.
• Osakwera pa heatsink kapena kwa dalaivala wa LED.

ZINDIKIRANI: Dalaivala ya LED iyenera kuthandizira DIM kuti OFF ntchito.
CHENJEZO NDI CHENJEZO

• TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!
• The CSEN1 should only be installed in a fixture with a Zhaga Book 18 receptacle.
• Kukanika kutsatira malangizo ndi machenjezowa kungathe kulepheretsa chitsimikizocho.
• This product must be installed in accordance with national, state, and local electrical codes and requirements.
• If you are unsure about any part of these instructions, consult an electrician; qualified personnel should perform all work.

ZAMBIRI ZONSE ZA ZHAGA BOOK 18 SOCKET

TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!
For fixtures with an existing Zhaga socket, prior to installation, verify the wiring per the details below. (See Figure 1) If the fixture does not have a Zhaga socket, use the appropriate Wired Adapter accessory based on the knockout size: CSEN1-ZHA-ADPT-22 for 22mm knockouts, or CSEN1-ZHA-ADPT-33 for 33mm knockouts. The specifications for the signal wires are:

• 12-24VDC POWER: Brown
• Common Ground/DALI-: Pink with White Stripe
• DALI+/DIM+: Violet with White Stripe
• Solid Conductor, 105°C, Rated for 600VAC, AWG 20, 15” Length

CHITHUNZI 1

MALANGIZO OYAMBIRA

TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE INSTALLING OR SERVICING!

1. Ngati n'kotheka, chotsani chosindikizira kapena chipangizo chowunikira chowunikira chomwe chayikidwa muchotengera choyikapo.
2. Align the CSEN1 such that the contacts pins are positioned at the appropriate the receptacle contacts.
3. After alignment, push until the CSEN1 is fully seated within the receptacle.
4. While pushing against the device, twist the CSEN1 housing clockwise until it locks into place. The CSEN1 includes a latching key or notch that will lock into position with an audible “click”. (See Figure 2)

Zindikirani: Kuti mugwire bwino ntchito, onetsetsani kuti chowongoleracho chalowetsedwa kwathunthu mu socket ndikupindika pamalo okhoma.
Chenjezo: The Zhaga receptacle should not turn during installation. Turning the receptacle could damage the internal fixture wiring by pulling it loose.
CHITHUNZI 2

NKHANI anatsogolera

Mphamvu ya magetsi	Mkhalidwe
Buluu	On for 3 seconds at Startup, then Off
Mkhalidwe wa LED	Mkhalidwe
Chofiira	No script on the device
Kuphethira kwa Red	Vuto Lolumikizana
Kuphethira kwa Blue	Communication, No Config
Kuphethira kwa Green	Normal Operation with Motion
Kuzimitsa	Normal Operation, no Motion

MALANGIZO OTHANDIZA NDI ZIZINDIKIRO
RF Exposure Statement: Chida ichi chikugwirizana ndi malire a FCC okhudzana ndi ma radiation omwe akhazikitsidwa kumalo osalamulirika. Zidazi ziyenera kuyikidwa ndikugwiritsidwa ntchito ndi mtunda wochepera 20cm pakati pa radiator ndi thupi lanu. Chotumizira ichi sichiyenera kukhala pamalo amodzi kapena kugwira ntchito limodzi ndi mlongoti wina uliwonse kapena chopatsira.
Satifiketi ya Industry Canada (IC): Chida ichi cha digito sichidutsa malire a Gulu B otulutsa phokoso la wailesi kuchokera ku zida za digito zomwe zafotokozedwa mu Radio Interference Regulations ya dipatimenti yolumikizirana ya ku Canada.
Ziphaso za FCC ndi zambiri zamalamulo (USA kokha)
FCC Gawo 15 Kalasi B: Chipangizochi chimagwirizana ndi gawo 15 la malamulo a FCC. Kugwira ntchito kumatsatira zikhalidwe ziwiri izi: (1) Zidazi sizingabweretse kusokoneza kovulaza, ndipo (2) Zidazi ziyenera kuvomereza kusokoneza kulikonse komwe kumalandira, kuphatikizapo kusokoneza komwe kungayambitse ntchito yovulaza.
RADIO FREQUENCY INTERFERENCE (RFI) (FCC 15.105): Zidazi zayesedwa ndipo zapezeka kuti zikugwirizana ndi malire a chipangizo cha digito cha Gulu B, motsatira Gawo 15 la malamulo a FCC. Malire awa adapangidwa kuti apereke chitetezo chokwanira ku kusokoneza koyipa pakukhazikitsa nyumba. Chipangizochi chimapanga, chimagwiritsa ntchito, komanso chimatha kuwunikira mphamvu zamawayilesi ndipo, ngati sichinayikedwe ndi kugwiritsidwa ntchito motsatira malangizo, chikhoza kusokoneza mawayilesi. Komabe, palibe chitsimikizo kuti kusokoneza sikudzachitika mu unsembe winawake. Ngati chipangizochi chikuyambitsa kusokoneza koopsa kwa wailesi kapena kulandirira wailesi yakanema, komwe kungadziwike mwa kuzimitsa ndi kuyatsa zida, wogwiritsa ntchitoyo akulimbikitsidwa kuyesa kuwongolera kusokoneza ndi chimodzi kapena zingapo mwa njira izi: (1) Kuwongoleranso: kapena kusamutsa mlongoti wolandira; (2) Kuonjezera kulekanitsa pakati pa zipangizo ndi wolandira; (3) Lumikizani zidazo munjira yopita kudera losiyana ndi lomwe wolandila amalumikizidwa; (4) Funsani wogulitsa kapena wodziwa ntchito pa wailesi/TV kuti akuthandizeni.
Declaration of Conformity (FCC 96-208 & 95-19): Synapse Wireless, Inc. declares that the product name CSEN1 to which this declaration relates, meet the requirements specified by the Federal Communications Commission as detailed in the following specifications:

• Gawo 15, Gawo B, la zida za Gulu B
• FCC 96-208 monga momwe imagwirira ntchito pamakompyuta amunthu a Gulu B ndi zotumphukira
• Izi zayesedwa mu Laboratory Yoyesa Zakunja yotsimikiziridwa malinga ndi malamulo a FCC ndipo zapezeka kuti zikugwirizana ndi FCC, Gawo 15, Malire Otulutsa. Zolemba zayatsidwa file ndi kupezeka kwa Synapse Wireless, Inc.

Ngati ID ya FCC ya module yomwe ili mkati mwa mpanda wazinthuzi sikuwoneka ikayikidwa mkati mwa chipangizo china, ndiye kuti kunja kwa chipangizochi komwe chidayikidwamo chiyeneranso kuwonetsa chizindikiro cholozera ku ID yotsekeredwa ya FCC. Zosintha (FCC 15.21):
Kusintha kapena kusinthidwa kwa zida izi zomwe sizinavomerezedwe ndi Synapse Wireless, Inc., zitha kulepheretsa wogwiritsa ntchito kugwiritsa ntchito chidachi.
Patented - chizindikiro chenicheni pa https://www.synapsewireless.com/about/patents
Kuti mudziwe zambiri pitani: synapsewireless.com

ZIZINDIKIRO

Chitsanzo	CSEN1-H-W-ZHA (white enclosure) or CSEN1-H-G-ZHA (gray enclosure)
Ili ndi ID ya FCC	QOQ-GM240P
Muli IC	Mtengo wa 5123A-GM240P
Chithunzi cha RoHS3	2011/65/EU (2015/863)
EU REACH	(EC) No 1907/2006

Woyang'anira Ntchito Wotsimikizika wa DALI-2

 

Zolemba / Zothandizira

Synapse CSEN1 Combo Sensor Controller [pdf] Kukhazikitsa Guide CSEN1-H-W-ZHA, CSEN1-H-G-ZHA, CSEN1 Combo Sensor Controller, CSEN1, Combo Sensor Controller, Sensor Controller, Controller

Maumboni

• Buku Logwiritsa Ntchito