SEIKO QHP012WLH Non-Ticking Melodies Alarm Clock User Manual

Mawu Oyamba

This manual provides detailed instructions for the SEIKO QHP012WLH Non-Ticking Melodies Alarm Clock. Please read this manual thoroughly before using the clock to ensure proper operation and to understand all features.

Zamkatimu Phukusi

• SEIKO QHP012WLH Alarm Clock
• 3 AA mabatire
• Buku la ogwiritsa (chikalatachi)

Zogulitsa Zamankhwala

• Chitsanzo: QHP012WLH
• Mtundu Wowonetsera: Analogi
• Kuyenda: Quartz yolondola
• Zapadera: Non-ticking quiet sweep second hand, selectable alarm melodies (Bird Song, Melodies, Beep), snooze function, adjustable alarm volume, light feature, luminous hour and minute hands.
• Gwero la Mphamvu: 3 AA mabatire (kuphatikizidwa)
• Makulidwe: Approximately 4.72 inches (W) x 5.12 inches (H) x 2.76 inches (D)
• Zofunika: Pulasitiki

Khazikitsa

1. Kuyika kwa Battery

The clock requires three (3) AA batteries for operation. These are included with your purchase.

1. Pezani chivundikiro cha chipinda cha batri kumbuyo kwa wotchi.
2. Remove the cover by sliding it down or lifting it off.
3. Insert three AA batteries, ensuring the correct polarity (+ and -) as indicated inside the compartment.
4. Sinthani chivundikiro cha chipinda cha batri mosamala.

Chithunzi: Kumbuyo view ya wotchi, kuwonetsa malo osungira batri ndi zolumikizira zowongolera.

2. Malo Oyamba Kuyikidwa

Place the clock on a stable, flat surface such as a bedside table or desk. Ensure it is away from direct sunlight, extreme temperatures, or high humidity.

Image: The alarm clock positioned on a wooden surface, demonstrating typical placement.

Malangizo Ogwiritsira Ntchito

Familiarize yourself with the controls located on the back and top of the clock.

Image: Rear controls of the clock, including time/alarm setting knobs and alarm switch.

1. Kukhazikitsa Nthawi Yapano

1. Locate the "TIME" setting knob on the back of the clock.
2. Rotate this knob clockwise or counter-clockwise to move the hour and minute hands to the correct current time.
3. Ensure the time is set accurately, especially for AM/PM if applicable (though this is an analog clock, consider the 12-hour cycle for alarm setting).

2. Kukhazikitsa Nthawi ya Alamu

1. Locate the "ALARM" setting knob on the back of the clock.
2. Rotate this knob to move the alarm hand to your desired wake-up time.
3. Ensure the alarm hand is precisely aligned with the desired hour and minute markings.

3. Kuyambitsa/Kuletsa Alamu

On the back of the clock, there is an "ON/OFF" slide switch for the alarm.

• Slide the switch to "ON" to activate the alarm.
• Slide the switch to "OFF" to deactivate the alarm.

4. Selecting Alarm Sound

The clock offers multiple alarm sound options: Bird Song, Melodies, or a traditional Beep sound. The selection dial is typically located on the side or back of the clock.

1. Locate the alarm sound selection switch or dial.
2. Choose your preferred alarm sound:
• Bird Song: A gentle natural sound.
• Nyimbo: Includes "Dance of the Hours," "Morning from Peer Gynt," and "Waltz of the Flowers."
• Beep: A standard electronic alarm sound.

5. Adjusting Alarm Volume

A volume control knob is provided to adjust the loudness of the alarm.

1. Locate the volume control knob, usually on the side or back of the clock.
2. Rotate the knob to increase or decrease the alarm volume to your preference.

6. Snooze Ntchito

When the alarm sounds, press the large button located on the top of the clock to activate the snooze function. The alarm will temporarily stop and sound again after a few minutes.

7. Light Feature

To illuminate the clock face in low light conditions, press the large button on the top of the clock. The light will remain on as long as the button is pressed, allowing for temporary viewing of the time.

Chithunzi: Patsogolo view of the clock, showing the dial and the top button for snooze/light.

Kusamalira

1. Kuyeretsa

To clean the clock, use a soft, dry cloth. Do not use abrasive cleaners, solvents, or chemical sprays, as these can damage the clock's finish and internal components.

2. Kusintha Battery

When the clock's display dims, the alarm weakens, or the clock stops functioning, it is time to replace the batteries. Follow the battery installation steps in the "Setup" section.

• Always replace all three AA batteries at the same time.
• Osasakaniza mabatire akale ndi atsopano, kapena mitundu yosiyanasiyana ya mabatire.
• Chotsani mabatire ngati wotchiyo sidzagwiritsidwa ntchito kwa nthawi yayitali kuti isatayike.

Kusaka zolakwika

Zofotokozera

• Nambala Yachitsanzo: QHP012WLH
• Mtundu: SEIKO
• Mtundu Wowonetsera: Analogi
• Gwero la Mphamvu: 3 x AA Mabatire (ophatikizidwa)
• Makulidwe (W x H x D): 4.72" x 5.12" x 2.76" (12cm x 13cm x 7cm pafupifupi.)
• Kulemera kwake: Pafupifupi ma 12.3 ounces (0.35 kg)
• Zofunika: Pulasitiki
• Zapadera: Non-ticking sweep second hand, selectable melodies, snooze, light, adjustable volume, luminous hands.

Chitsimikizo ndi Thandizo

Chidziwitso cha Chitsimikizo

This SEIKO QHP012WLH alarm clock is covered by a Chitsimikizo chochepa cha opanga zaka 1 kuyambira tsiku logula. Chitsimikizo ichi chimakwirira zolakwika muzinthu ndi kapangidwe kake pansi pakugwiritsa ntchito bwino.

Chitsimikizo sichimakhudza:

• Damage caused by accident, misuse, abuse, alteration, or improper installation.
• Damage caused by unauthorized service.
• Damage from battery leakage.

Chonde sungani umboni wanu wogula kuti mupereke chitsimikizo.

Thandizo la Makasitomala

For technical assistance, warranty claims, or further inquiries, please contact SEIKO customer support. Refer to the official SEIKO webtsamba lanu kapena zopangira zanu kuti mudziwe zambiri zaposachedwa.

You can visit the official SEIKO website for support and product information: www.seikoclocks.com