SIGNATURE HARDWARE MCBRYDE Vanity Light
SKU: 946305, 946306, 476884, 476885
We recommend consulting a professional if you are unfamiliar with installing electric ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. Observe all local plumbing and building codes. Unpack and inspect the product for shipping damage. If any damage is found, contact our Customer Relations team via live chat at www.signaturehardware.com kapena kudzera pa imelo email@example.com.
Onetsetsani kuti mwapeza zofunikira zonse zofunika pakukhazikitsa.
CHENJEZO: Be sure the electricity to the wires you are working on is shut oﬀ, either the fuse is removed or the circuit breaker is shut oﬀ. You do not need special tools to install this ﬁxture. Be sure to follow the steps in the order given. Under no circumstances should a ﬁxture be hung on house electrical wires, nor should a swag type ﬁxture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualiﬁed electrician.
MALANGIZO A CARE
To clean, wipe ﬁxture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
SUNGANI KABWINO IYI:
RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATION QUESTIONS PLEASE CALL CUSTOMER SERVICE AT 1-800-221-3379.
INSTALLATION (FIG 1 & 2)
- Remove mounting plate (B) from ﬁxture back plate (F) by removing the ﬂat head screws (D) – see Figure 1 & 2.
- Connect positive supply wire in black to positive ﬁxture lead with connector. Connect negative supply wire in white to negative ﬁxture lead. Connect the ground wire (green or bare copper) with ﬁxture’s ground wire with connector. Tuck the wire connections neatly into the junction box.
- Deslice los cables de la caja de conexiones (A), a través del oriﬁcio central, asegúrese de que las ranuras de la placa de montaje (B) se alineen con los oriﬁcios roscados(E) en la caja de conexiones (A).
- Use two screws (C) to attach the mounting plate (B) to the junction box (A).
- Mount the ﬁxture by sliding the back plate (F).
- Attach the back plate (F) to the mounting plate using the ﬂat head screws (D).
INSTALLATION (FIG 3 & 4)
- To install glass (3), slip small hole in bottom of glass over the socket (4) – see Figure 3 & 4.
- Thread socket ring (2) onto socket (4) and tighten to secure glass.
- Install the light bulbs (1); not included, in the sockets (4).
Zolemba / Zothandizira
|SIGNATURE HARDWARE MCBRYDE Vanity Light [pdf] Buku la Malangizo|
946305, 946306, 476884, 476885, MCBRYDE Vanity Light, MCBRYDE, MCBRYDE Light, Vanity Light, Light