GIANNI INDUSTRIES GK140 Electric Strikes Instruction Manual
zofunika
- Opaleshoni Voltage: 12 kapena 24 VDC
- Voltage Tolerance: ± 10%
- Zojambula Zamakono: 700mA/12VDC ; 350mA/24VDC
- Kutentha Kwambiri: 14°F to 120°F (-10°C~+49°C)
- Chinyezi: 0 ~ 85% osavomereza
- Solenoid Testing: Zozungulira zopitilira 250,000
- Sakanizani: Mpaka ma lbs 200
- Static Strength: 1,200 lbs (GK140 Series) 1,000 lbs (GK145 Series)
- Ntchito yomanga: Chitsulo chosapanga dzimbiri
- Kalemeredwe kake konse: 673g
- Latch Throw: GK140: 15 mm, GK145: 11 mm (With 3mm door gap)
- Keeper Width: 48mm
- Lock Mode: Kulephera-chitetezo
Chenjerani!
Please follow the sticker’s instruction to install the strike.
Keeper Adjustment (GK145 Only)
The strike keeper can be adjusted horizontally to account for various installation anomalies. To adjust the keeper, loosen the adjustment screws, move the keeper horizontally as needed, and retighten the adjustment screws. (Maximum adjustable range: 3mm)
Handing Guide
Door handing is determined from the side of the door where the hinges are visible, according to the German standard DIN 107. Stand facing the door on the hinge / pull side. If the hinge is on the right, the door is considered to be DIN right. If the hinge is on the left, then the door is considered to be DIN left.
Models (M: Door Status Monitor)
| DIN left | DIN right | ||
| GK140-L-12 | GK145-L-12 | GK140-R-12 | GK145-R-12 |
| GK140M-L-12 | GK145M-L-12 | GK140M-R-12 | GK145M-R-12 |
| GK140-L-24 | GK145-L-24 | GK140-R-24 | GK145-R-24 |
| GK140M-L-24 | GK145M-L-24 | GK140M-R-24 | GK145M-R-24 |
Mabulaketi Osasankha
Mabulaketi owonjezera milomo amapezeka kuti apangitse ma jamb okulirapo.
Mortise Mount in Wooden Frame
Chithunzi cha Wiring
Kukhazikitsa Mapulani
- Measure the vertical and horizontal position of the latch bolt on the door leaf.
- Mark the position of the latch bolt on the door frame as shown in the figure.
- Mount the supplied template and align to the marked line.
- Boolani ndi kudula chimango molingana ndi template.
- Tighten the indicated screws.
- Connect the wires and install the strike.
Zindikirani
It must be ensured that there is a small space between the latch bolt and actuated latch stop when the door is closed and the latch bolt is in its locked position. This will relive pressure on the solenoid valve and reduce the risk of failure when opening the door.
Zolemba / Zothandizira
 |
GIANNI INDUSTRIES GK140 Kumenya Magetsi [pdf] Buku la Malangizo GK140 Electric Strikes, GK140, Electric Strikes, Strikes |
