15W WIRELESS CHARGER
MANERO OBUKA
74T0 15W Wireless Charger module
Charger module
Model Number – 74T0 
Zindikirani: Chonde werengani bukuli kuti mugwiritse ntchito moyenera ndikulisunga kuti mudzagwiritse ntchito mtsogolo.
Charger module with Garnish, Antiskid Mat & Mounting clips 
SECTION 1.0 Warning
Observe the following precautions. Failure to do so may result in the possibility of equipment failure or damage, or burns due to heat.
- While charging, do not put any metallic object between the charging area and the i. mobile phone.(Coin, ATM card, clip etc…)
- Do not attach metallic objects, such as aluminum stickers, to the mobile phones
- Do not cover the wireless charger with a cloth or other object while charging.
- Do not attempt to charge mobile phones which are not compatible with the i. Qi wireless charging standard.
- Do not disassemble, modify or remove the wireless charger.
- Do not apply force or impact to the wireless charger.
SECTION 2.0 Product Description
Mobile phones can be charged by just placing them on the charging area, if the Mobile phone is compatible with the Qi wireless charging standard created by the Wireless Power Consortium.
MAKHALIDWE AMAGAKA
| katunduyo | mfundo |
| KUGWIRITSA NTCHITO VOLTAGE ZOSIYANA | 6V ~ 16V |
| opaleshoni | |
| OUTPUT POWER (AT RECEIVER DEVICE) | 5W AT 6V -9V 15W AT 9V – 16V |
| STANDBY TSOPANO | ∼ 50mA |
| TYPICAL CURRENT (@12V) | ∼ 1.9A |
| MAX CURRENT CONSUMPTION (@9V) | ∼ 2.6A |
| DARK CURRENT | LESS THAN 1mA |
| INRUSH CURRENT | 4.5A FOR 5ms |
| OPERATING FREQUENCY (PEAK) | 127.7±10KHz |
| CHARGING EFFICIENCY (AS PER Qi) | MIN 70% |
| ACC CURRENT | 100mA (MAX) |
| Qi VERSION | 1.2.4 |
TEMPERATURE CHARACTERISTIC
| katunduyo | mfundo |
| RANGE OF STORAGE TEMP | -40 ~ 85(˚C) |
| RANGE OF OPERATING TEMP | -40 ~ 80(˚C) |
GENERAL CHARACTERISTIC
| katunduyo | mfundo |
| INGRESS PROTECTION (MODULE TOP SURFACE) | IP 65 |
| CHIONSE CHONSE | 350g (MAX) |
| MAFUNSO A COMPATIBLE | Qi COMPLIANT RECEIVER DEVICES |
SECTION 3.0 Connector Details
| PIN # | Dzina la Terminal | Kulumikizana |
| 1 | +B | Gwero la Mphamvu |
| 2 | ACC | Kuyika kwa ACC |
| 3 | KODI H | AMAGWIRITSA NTCHITO |
| 4 | KODI L | ANGACHECHE |
| 5 | NC | Osalumikizidwa |
| 6 | NC | Osalumikizidwa |
| 7 | KLVC | LF Search Signal |
| 8 | GND | Mphamvu Ground |
| PIN # | Kulumikizana |
| 1 | 5V |
| 2 | NC |
| 3 | NC |
| 4 | ONANI / PA NTCHITO |
| 5 | GND |
| 6 | LED_R |
| 7 | LED_G |
| 8 | LED_B |
| 9 | DEBUG_5V |
| 10 | CHIWERE |
| 11 | DETA |
| 12 | GND |
Zindikirani : PIN # 9 to 12 is meant for Debug
| PIN# | Kulumikizana |
| 1 | LED_R |
| 2 | LED_G |
| 3 | LED_B |
| 4 | ON/OFF SWITCH (Reserved) |
| 5 | GND |
| 6 | NC |
SECTION 4.0 User Instructions
- The Wireless Charger will automatically turn ON after 4 seconds when the car ignition is on and all the doors are closed. The LED charging indicator will turn Amber during Standby mode.
- Place the mobile phone into the wireless charger charging area and make sure it is aligned properly to the center of the charging area.
- The LED Charging indicator light will change from Amber to blue once the charging begins.
After the charging is complete, the Blue light will change to Green.
Recharging ntchito
➢ If a certain amount of time has elapsed since charging completed and the mobile has not been moved, the wireless charger will restart charging.
➢ If the portable device is moved within the charging area, charging will stop temporarily and then restart.
| Chizindikiro Chotsitsa cha LED | kachirombo | |
| chitsanzo | mtundu | |
| No light up | - | • Wireless charger is Off / sleep state |
| Yatsani | Amber | • Wireless charger is On (Standby Mode — waiting for receiver to charge) |
| Yatsani | Blue | • Charging in progress |
| Yatsani | Green | • Charging completed |
| Blinks (20 times) | Red | • Detect foreign object • Charging error • Overheat condition |
| Yatsani | Red | • Permanent failure error |
*Zindikirani: No inbuilt charging indication LED available in the wireless charger.
SECTION 5.0 Precaution
- Always remove foreign objects from the charging area before charging the portable
i. device. - Be sure the surface of the charging area is clear of dust and other debris before
i. charging. - Do not spill liquids (i. e. water, drinks, etc.) on the Wireless charger.
- Do not use oil, grease, alcohol, benzine or thinner to clean the anti-slip sheet.
- Do not try to peel off the anti-slip sheet from the wireless charger.
- While charging, do not cover the Wireless charger with a towel, cloth, or other objects.
- Avoid spraying aerosols which may come in contact with the charge pad surface.
- Depending on the type of cover and/or accessory attached, it may not be possible to charge the mobile phones. If the mobile phone is placed in the charging area and does not charge, remove the cover and/or accessories.
- While charging, the wireless charger and the portable device will become warm.
i. This is not a malfunction. If a portable device becomes warm while charging and
ii. charging stops due to its protection function, wait until it cools down and charge it again.
SECTION 6.0 Notice
- Charging will be suspended temporarily when any door is opened.
a. Charging will resume after the door is closed. - Mobile phones compatible with the Qi wireless charging standard can be charged
a. by the wireless charger. However, compatibility with all devices which meet the
b. Qi wireless charging standard is not guaranteed.
In the following situations, the wireless charger may not operate correctly:
- When the mobile phone is fully charged.
- When the mobile phone becomes hot while charging.
- When the ambient temperature is high.
- When the mobile phone is not centered on the charging area.
- When there is a foreign object between the charging area and the mobile phone.
I. Cards (ATM, ID, RFID & SIM etc..)
II. Gum wrapper(aluminium foil)
III. Nyama Clip
IV. ndalama
V. Ochapira Zitsulo
VI. Metal Bracelet
VII. Kopanira mapepala
VIII. ndolo
IX. Zomangira zazing'ono
X. Key, keying, smart key etc….
Manufactured by: APTIV Connection Systems India Pvt Ltd.
7/60-A & 60-B
ARAKUNNAM PULICKAMALY RD
ARAKUNNAM, MULANTHURTHY-KOCHI 682313
KERALA, INDIA
SECTION 7.0 FCC Rule
Chida ichi chimatsatira Gawo 15 la Malamulo a FCC.
Ntchito ikugwirizana ndi izi:
- chipangizochi sichingayambitse mavuto komanso
- chipangizochi chiyenera kuvomereza kusokonezedwa kulikonse komwe kulandiridwa, kuphatikiza kusokonezedwa komwe kungayambitse ntchito yosafunikira.
Federal Communications Commission (FCC) Statement 15.105(b):
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Chidachi chimapanga, chimagwiritsa ntchito ndipo chimatha kutulutsa mphamvu zamagetsi ndipo, ngati sichinaikidwe ndikugwiritsidwa ntchito mogwirizana ndi malangizo, zitha kusokoneza kuyankhulana kwawailesi. Komabe, palibe chitsimikizo kuti kusokonezedwa sikungachitike pakukhazikitsa kwina. Ngati chipangizochi chikuyambitsa vuto pakulandila wailesi kapena wailesi yakanema, zomwe zingadziwike mwa kuzimitsa zida zonse, wogwiritsa ntchito amalimbikitsidwa kuti ayesere kusokoneza mwa njira imodzi kapena zingapo izi:
- Konzaninso kapena sinthani antenna yolandila.
- Lonjezani kupatukana pakati pazida ndi wolandila.
- Lumikizani zida zogulitsira pa dera losiyana ndi lomwe wolandirayo walumikizidwa.
- Funsani wogulitsayo kapena waluso pa TV / TV kuti akuthandizeni.
Compliance statement 15.21:
Mukuchenjezedwa kuti kusintha kapena kusinthidwa kosavomerezedwa ndi gawo lomwe likutsatira kumatha kupangitsa kuti wogwiritsa ntchitoyo asagwiritse ntchito zida zake.
Chiwonetsero cha FCC RF Radiation Exposure:
- Chopatsachi sichiyenera kukhala limodzi kapena kugwira ntchito limodzi ndi mlongoti wina aliyense kapena chopatsilira.
- The Transmitter shall always be installed ensuring a minimum separation distance of 20cm between the antenna and the user.
Zolemba / Zothandizira
 |
APTIV 74T0 15W Wireless Charger Module [pdf] Buku Logwiritsa Ntchito 74T0, 2A9QJ-74T0, 2A9QJ74T0, 74T0 15W Wireless Charger Module, 15W Wireless Charger Module, Wireless Charger Module, Charger Module, Module |
