AiM GPS09C Open Module

GPS09C Open gawo

Njira

The GPS09C Open features three output streams:

  • Open CAN connection. Freely user configurable
  • Open RS232 connection. Freely user configurable
  • AiM CAN connection. To be connected as expansion in the AiM CAN network
    Njira

The module comes with a 7-pin connector, as shown in fig 1, to which you may connect the proper cable, in dependence upon the connection you need to manage:
Njira
Njira

kasinthidwe

In order to configure the GPS09C Open, you need to connect it to your PC using the proper cable:
kasinthidwe

After having connected the GPS09C to your PC USB cable, you have to run our software RaceStudio3 and use the configuration manager for configuring it.
kasinthidwe

CAN Bus connection

CAN Bus connection

If you select the CAN Open stream, you may configure the CAN messages you need.
It is possible to set the baud rate for the CAN bus and, for every message:

  • ID
  • DLC (1- 8 bytes)
  • Bye order (little endian, big endian)
  • Message frequency (1-5-10-25 Hz)
    CAN Bus connection

The information the GPS09C Open may transmit in CAN are:

  • Kutalika
  • Latitude
  • Longitude
  • Sats number
  • Pos Accuracy
  • Liwiro Lolondola
  • GPS Lateral acceleration
  • GPS Linear acceleration
  • GPS Heading
  • GPS Yaw rate
  • GPS Hour
  • GPS Min
  • GPS Sec
  • GPS Millisec
  • chaka
  • mwezi
  • tsiku
  • Nambala ya sabata
  • ITOW
  • Nthawi Yapadera
RS232 Messages

If you set the GPS09c in order to transmit the data through the RS232, it will transmit the standard NMEA messages.
RS232 Messages

It is of course possible to set all the parameters related to the RS232 protocol, and the frequency at which every message is transmitted.

The messages the system may transmit are:

  • NMEA DTM
  • NMEA GBS
  • NMEA GGA
  • NMEA GLL
  • NMEA GNS
  • NMEA GRS
  • NMEA GSA
  • NMEA GST
  • NMEA GSV
  • NMEA RLM
  • NMEA RMC
  • NMEA VLW
  • NMEA VTG
  • NMEA ZDA
  • NMEA TXT

The meaning of all these NMEA messages is described in www.nmea.org

AiM CAN connection.

In case you need to connect the device in an AiM CAN Network, you have to select AiM CAN Connection:
the device is automatically managed by the AiM dash or Logger, so you don’t need to configure anything else.
AiM CAN connection

Logo ya AiM

Zolemba / Zothandizira

AiM GPS09C Open Module [pdf] Buku Logwiritsa Ntchito
GPS09C Open, Module, GPS09C Open Module
AiM GPS09C Open Module [pdf] Wogwiritsa Ntchito
GPS09C, GPS09C Open Module, Open Module, Module

Zothandizira

Kusiya ndemanga

Anu email sati lofalitsidwa. Amafuna minda amalembedwa *